Crafts

Winter decoration

Whether you have snow or not, december is a great time to start with the winter decoration. Therefore, here’s a tutorial on three different paper snowflakes.

For each snoflake, prepare an A4 sheet of paper and also have a pair of scissors, a pencil, some glue and a ruler at hand.

SNOWFLAKE NR. 1

For the first snowflake, cut 12 stripes 20 cm long and 0,5 cm wide. You will need to make 2 halves of the snowflake and for each you’ll need 6 of those stripes.

 

Place three stripes next to each other with just a small distance and then three stripes over them perpendicularly. You need to weave the stripes where they cross. Start with the first perpendicular stripe over the first stripe, under the second stripe and over the third stripe. The second perpendicular stripe should start under the first stripe, over the second and under the third. And the last perpendicular stripe same like the first one. Glue the stripes where they cross each other.

Take two corner stripes next to each other, twist their ends together and glue. Do this in the remaining three corners as well.

This is the result. Now make another shape like this with the other six stripes.

 

Place both halves on each other so that the snowflake is nice and round. Pull the free stripes of one half through the “leaves” of the other half.

Glue the stripes to the leaves.

Cut off the stripes that are too long.

 

SNOWFLAKE NR. 2

Cut a square from the paper, any size will do.

 

Fold the square diagonally three times.

Draw a pattern. The dark parts are those you’ll cut out together with the top (on the left in the photo).

Cut the top and the indicated parts.

Open the snowflake.

 

SNOWFLAKE NR. 3

Cut out 6 squares and again, the size doesn’t matter but the bigger the easier to work with. Mine are 9 x 9 cm.

Now cut stripes on two sides next to each other. Don’t cut all the way to the center so your square doesn’t fall apart. You need the same amount of stripes on each side and they should have the same width.

Take the first pair of stripes and glue their ends together.

Do the same with the second pair but on the other side of the square.

So each pair will be connected on another side of the square. Keep connecting the stripes alternating the sides.

Or you can do one side first and then the other.

This is the result. Repeat all the steps with the remaining five squares.

The you need to connect all six parts. You glue their bottom ends together, which will actually be the center of the snowflake.

Keep on adding…

…until all 6 parts are joined together and your snowflake is done.

Líbí se vám to? Sdílejte!

You may also like...

2 Comments

  1. beautiful. is this one of origami too? what it’s called?

    1. Tvořivá máma says:

      This is no origami, i don’t know what this technique is called.

Leave a Reply

Your email address will not be published. Required fields are marked *